(1) Door hinges—the top edge of the upper piece of the hinge should be 15 cm from the edge of the orange notch of the door, and the bottom edge of the lower piece should be 25cm from the finished floor; if there are three hinges, the middle piece should be assembled on the upper and lower two The center of the chip pitch.
(2) The assembly position of the door hinge, door stop and handle of the service desk shall be specified by the designer. (3) For door locks, unless otherwise specified, the center of the lock handle should be lm away from the finished floor.
(3) All hardware assembly should strictly abide by the manufacturer’s instructions. When installing hardware, if you use wood screws to tighten, you should first use a wood drill to half the length of the screws themselves, and then screw the screws in In any case, do not use a mace to drive the screw directly.